VisuNet XT-9700, Руководство пользователя

Страница: 27 / 81

VisuNet XT 9700 Series
Hardware Installation
Vi
suNet
XT
9
700
Seri
es
25
3. Thread sixteen #10-32 Phillips pan head screws (item 7) into the threaded holes in the
frame until they just protrude from the other side. Do not thread them in all of the way.
4. Look at the back of the XT unit and find the six threaded mounting holes. There are two
along the top, two along the bottom, and one on each side. Refer to Figure 4.14 .
5. Look at Figure 4.13 and Figure 4.14 to see the proper orientation of the panel mount
bracket assembly.
6. Install the XT unit (item 1) through the panel cutout (item 2) from the front side.
7. From the back side of the panel, place the panel mount bracket assembly over the XT unit
and secure the bracket assembly to the XT unit with six #6-32 Phillips pan head screws.
Tighten the screws to 1.2 Nm (11 in.-lb.).
8. Secure the XT unit to the panel by tightening the sixteen #10-32 Phillips pan head screws
(item 7) against the back side of the panel. Tighten the screws to 1.2 Nm (11 in.-lb.).
Figure 4.12 XT Unit Gasket
Note!
make sure the surface is clean and free of any surface contaminants before installing the XT
unit.