42
QNVR Installation Manual V1.2
QNVR installation and user manual
Note
: Playback following time change
The NVR uses the time and date to index video on the hard disk drive so you can find it later.
Changing the time can cause the NVR to work improperly, when you try to play back video. If
you set the hour ahead, this is not a problem. But, if you set the hour back, there will be more
than one recording with the same time stamp.
Such as during the October Daylight Saving Time changeover, if you try to search for video
between 1 am and 2 am, the recorder may not operate properly because there will be two
hours of recorded video during this time period. To view video during this overlapping time
period, you must start playback before 1 am, then recorder will play both hours between 1
am and 2 a.m.
You cannot do a backward search through the overlapping time. But, you can do forward
search.
IR Remote Address
The remote control can be used to control up to 16 QNVRs, the ID number on each can be
set to a unique address so that the remote will only control one at a time if they are in close
proximity. The default is 11.
Repeated click on the ID value to change to the required number.
To select a unit on the remote control press the ID button, followed by
the number, followed by the ID button again. The LED will flash slowly.
VGA resolution
The VGA resolution can be set from 1024x768 to 1920x1080.
HDMI resolution
The HDMI resolution can be set to 1080i, 1080p and Auto.
Initialization
All the menu settings will be returned to the factory default. To carry out this function the
system recording will have to be turned off.
Information
The Information Screen shows the hard disk size, current firmware vision, IP address* and
MAC address*.
* IP & MAC address ;
1
: Network port for IP camera
2
: Network port for PC client
3
: Network port for NAS (For future development)
If the country does not appear
in the list, use the User define
option.
