Vista Q4-XXXh, Инструкция по установке и эксплуатации

Страница: 35 / 129

35
Quantum EVO H.264 installation and user manual
Auto Delete Mode
Auto Delete Mode can be set to automatically erase recorded older than a certain number of
days. This can be set between 0 and 99 days.
Date Format
The default is dd-mm-yyyy. Other date formats available are: mm-dd-yyyy / / yyyy-mm-dd.
Time/DST Setting
The DVRs time can be set by clicking on the time and date displayed in this section, the on
screen keyboard will appear. Set the time and date and click Ok, next select the country to
enable the Day Light Saving mode.
PLAYBACK FOLLOWING TIME CHANGE
The DVR uses the time and date to index video on the hard disk drive so you can find it later.
Changing the time can cause the DVR to work improperly, when you try to play back video. If you set
the hour ahead, this is not a problem. But, if y ou set the hour back, there will be more than one
recording with the same time stamp.
Such as during the October Daylight Saving Time changeover, if you try to search for video between
1 am and 2 am, the recorder may not operate properly because there will be two hours of recorded
video during this time period. To view video during this overlapping time period, you must start
playback before 1 am, then recorder will play both hours between 1 am and 2 a.m.
You cannot do a backward search through the overlapping time. But, you can do forward search.
The Time and Date and the DST time can be changed from the front panel, the Mouse or the Remote
Control
Video Type
Video Type can set in this menu without rebooting or initialisation. The default is PAL, NTSC
can also be selected
System ID
The remote control can be used to control up to 16 Quantum‟s, the ID number on each can
be set to a unique address so that the remote will only control one at a time if they are in
close proximity. The default is 11.
Repeated click on the ID value to change to the required number.
To select a unit on the remote control press the ID button, followed by the number, followed
by the ID button again. The LED will flash slowly.