Vista Q4-XXXh, Инструкция по установке и эксплуатации

Страница: 14 / 129

14
Quantum EVO H.264 installation and user manual
ALARM CONNECTIONS
The Alarm connections are made via the push in connectors on the rear on the unit. There are 16
individual alarms inputs marked as Sensor In (1-16) and 2 Outputs marked as Alarm, plus 2 ground
connections. As shown below:
KEYBOARD
OR CAMERA TELEMTRY use one of the RS485 + and - connection pairs, the second
pair can be used to loop out to subsequent DVRS.
Note: The function of the RS485 port is set in Main Menu/System/Etc./RS485. Here it can be set to be
either:
PTZ camera
– For telemetry control via the front panel for PTZ domes
Or
PTZ Controller
– Where the port is set for use by the remote keyboard. In this mode the PTZ
dome telemetry must be taken from the output on the keyboard
ALARM INPUT use the Sensor In and the GND ( See Page 31 for detail on Alarm set-up and response)
ALARM OUT use the Alarm A and B pair
RS485 ports are configured
in menus, to be either PTZ
control
OR for connecting a
remote keyboard. It can not
do both at the same time