TRUSS FRAME
TIE IN PLATE
DC-1234
DC-1234
DC-1234
DETAIL ONE
2 1/2" ROBERTSON SCREWS
20 req
THE TRUSS FRAME ASSEMBLY MUST REMAIN SQUARE.
DOUBLE CHECK CORNER-TO-CORNER MEASUREMENTS
ONCE BRACES ARE ATTACHED.
LAY THE SQUARED TRUSS FRAME ASSEMBLY AT THE EXACT
LOCATION YOU WISH YOUR GAZEBO TO BE.
USING A PENCIL OR MARKER, TRACE THE OUTSIDE EDGES
OF ALL FOUR CORNERS ONTO THE GROUND.
THESE MARKINGS WILL BE HELPFUL IN PLACING YOUR
CORNER POSTS AND PANELS IN THE STEPS TO COME.
ONCE MARKINGS ARE COMPLETE, MOVE THE TRUSS FRAME
UP AND OUT OF THE WAY.
MAKE REFERENCE MARKS
B
Mt. BLANC
Mt_Blanc_11x11_Instructions_V1.0
TOLL FREE: 1-877-795-7423
EN
STEP 3
WHEN BOTH OF THE TRUSS FRAME ASSEMBLIES ARE SQUARE,
ATTACH THE TIE IN PLATES (DC 1234) AT EACH SIDE AS SHOWN.
PLACE THE TIE IN PLATES IN BETWEEN THE TRUSS FRAME
BRACES. MAKE SURE THE TOP PLATES OF EACH TRUSS FRAME
ARE BUTTED TIGHT TOGETHER.
ATTACH THE TIE IN PLATE WITH 2 1/2" SCREWS AS SHOWN. MAKE
SURE THE PIECES ARE FLUSH TO THE OUTSIDE OF THE TRUSS
FRAME ASSEMBLY. PLACE THE SCREWS ON EITHER SIDE OF THE
DADO AS SHOWN IN
DETAIL ONE
