Table
of Contents
42
A
PPENDIX
B: T
ROUBLESHOOTING
■
Connect the scanning keyboard to another computer where the
PaperPort software is already installed.
■
Install and use one scanning keyboard on the computer and then
connect a different scanning keyboard to the computer.
To recalibrate the PaperPort scanning keyboard:
1. Use the calibration page that you received with the scanning keyboard,
or cut or fold a blank, white piece of paper so that it is 9 inches
(22.9 cm) wide and at least 6 inches (15.2 cm) long.
2. Click the Settings button on on the Command Bar. If you’re using
Windows 95, click the Scanner Setup tab.
3. Click the Setup button to display the scanning keyboard Setup
dialog box.
4. Click the Calibration button. A message asks you to insert the paper
to begin calibrating the scanning keyboard.
5. Insert the 9-inch (22.9 cm) edge of the paper into the center of the
scanning keyboard’s page feed slot. Or click Cancel to skip the
calibration.
Book Page 42 Monday, December 2, 1996 1:30 PM
