AVN422HD User’s Manual
Chapter 6 Using the Browser Interface
23
6.4.4 Channel Stream
The Channel Stream page allows the configuration of the Stream Output Control.
Stream Mode
– Displays the current Stream Mode and allows the editing of this parameter.
Possible values are:
Transport Stream UDP (13818-1 MPEG-2 TS) *Default
Transport Stream RTP (13818-1 MPEG-2 TS) + RTP encapsulation
Stream Destination
– Displays the current Stream Destination and allows the editing of this
parameter. The format of this parameter is the destination IP address, colon ":" and then the
destination port number (
xxx.xxx.xxx.xxx
:
xxx
).
Stream at Bootup
– Displays the current Stream at Bootup time in seconds and allows editing of
this parameter. Possible values are: 0 to 90 seconds. Note that a value of 0 means Stream at
Bootup will be disabled (the AVN422HD will not automatically start streaming upon boot up).
Stream Kicker
– This parameter controls if and when a running / playing stream gets
automatically restarted (stopped then started). If set to 0, the stream will not be automatically
restarted but will continue to play until stopped by the user. If set to a value greater than zero, the
stream will be automatically restarted every
X
minutes where
X
equals the configured number.
The default value is 0 / disabled.
Stream TTL
– This parameter controls the streams Time-To-Live (TTL), which is effectively the
number of network "hops" that the stream will cross before "dying." For Unicast streams, TTL
values are defined as network segments, which are effectively routers/switches. For Multicast
streams, the TTL value is more loosely defined as "scope" which is network dependent and not
always directly associated with network segments. The default value is 8.
Stream QOS
– This parameter controls the stream Quality of Service (QOS) through a network.
Parameters P0 through P2 are precedence bits (0 to 7, 0 is highest). D is a low delay request bit.
Содержание AVN422HD
Страница 6: ...Contents AVN422HD User s Manual vi...
