Vision X UNITE Series, Руководство по установке

Страница: 8 / 12

8
VISIONXLIGHTING.COM
INSTALLATION INSTRUCTIONS
MOUNTING INSTALLATION INSTRUCTIONS
1. Determine where the light/lights will be placed.
2. Place mounting bracket with light to desired location. Using a marker or
pick tool, mark the center point of the bolt hole on the mounting surface.
3. Set the light aside. Drill out a large enough hole to fit the mounting bolts.
4. Using a 13mm socket wrench, secure the light to the mounting surface
with the provided Mounting Bolts followed by a Washer and Nylock Nut.
WIRING INSTALLATION INSTRUCTIONS
1. Find a suitable place to mount Relay Part (R1) leaving enough room
for Power & Ground wires Part (W1 & W2) to reach the battery & the
Deutsch connector Part (C1) to reach the Light. Mount Relay.
2. Run Power wire (W1) & Ground wire (W2) to the battery. Connect the
Power wire (W1) to the Positive (+) battery terminal and connect the
Ground wire (W2) to the Negative (-) battery terminal.
3. Run the Deutsch connector wire (C1) to the light and plug in.
4. Disconnect the Switch Part (S1) at the white Plug Part (P1) and run the
wire through the vehicles fire wall to desired mounting location inside the
Cab [using a factory rubber or plastic grommet is suggested].
5. Drill the hole to the required size for the Switch (S1) and mount to
desired position.
6. Reconnect the Switch (S1) to the Harness.
7. Test Light.
MULTI-CIRCUIT WIRING NOTES:
• For Multi-Circuit Wiring , you would follow the same steps as above, but
utilize multiple harnesses depending on the amount of circuits used.