Instruction Manual – Verdanium Geo – Ver. 1.1.1 – 12.2021
Instruction Manual – Verdanium Geo – Ver. 1.1.1 – 12.2021
40
41
Electrical connection
The Verdanium Geo is equipped with an IEC socket, which has an integrated fuse and a power switch.
A Power cord with a length of approx. 1.8 m is supplied with the Verdanium Geo.
Only connect the Verdanium Geo to an electrical system complying with VEM 0100
standard.
The electrical plug must always be easily accessible to unplug the Verdanium Geo from
the electrical grid.
The unit label on the upper rear part of the housing provides information about the nominal power input
and the corresponding fuse.
The information provided on the label must be compatible with the electrical grid.
•
Connect the Verdanium Geo with the supplied power cable to the electrical grid.
•
When the power switch ( I ) is turned on, the Verdanium Geo starts and waits for the initial
commissioning to begin.
Control buttons
The Verdanium Geo is controlled by using the
keypad. The following functions are available:
•
System activation
•
System deactivation
•
Check system operation time
•
Reset filter change interval
Display
The display shows various functions and opera-
ting status of the Verdanium Geo:
•
Status of the system
•
Information about filter change
•
Rinsing times
•
Operating times
•
Error messages
Interface
The interface is used to update the software of
the Verdanium Geo.
Please note that this interface is only to be
accessed by authorised service providers. Any
interference with the control system irrevocably
leads to the loss of warranty.
Controls
