ViscoTec PreeFlow eco-CONTROL EC200 DUO, Инструкция по эксплуатации и техническому обслуживанию

Страница: 14 / 44

Dosing system eco-CONTROL EC200 DUO
Operating and maintenance instructions
14 / 43 Version 1.4 Copyright ©
5.5 Starting up for the first time
• Operate the 2K-dispenser in accordance with the operating manual.
• Ensure that the mains switch has been turned off.
• Funktionsbereitschaft des 2K-Dispensers gemäß der mitgelieferten Inbetriebnahme-
und Wartungsanleitung herstellen.
• Connect the plugs of the 2K-dispenser(s).
• Connect the plugs of both 2K-dispenser pressure sensors.
• Connect the power supply to the control system.
• Connect the mains plug of the mains adapter to the electrical mains.
• Turns on the mains switch.
5.5.1 Save the calibration values of the dosing pressure sensors
Notice: The Dosing system is only ready for operation when the 2K-dispenser is
connected.
Tip: Use the stickers provided (letters A and B), to mark the following components.
- Both motors and dispensers and their plugs
- Pressure sensors and their plugs
- Supply lines for the media used
Caution: The 2K-dispenser lead (connector 16, Chapter 5.2, Connections on page 11)
may only be connected and disconnected when the power supply is isolated. The
electronics in the drive motor could be damaged if this precaution is not taken.
• Press PRG , system selection menu ,
display 2 appears.
• Select Administration , display 25 appears.
Displa
y 2
• Select Calib. outp. pressure A , display 51 appears.
Displa
y 25
• Enter the calibration data supplied with the sensor
• Carry out the same setting with pressure sensor B.
Display 51
Calibration auto
Calibration manuell
Service
Flush manually A
Flush manually B
Administration
Programs
10 47h
Fr 18.03.11
Insert value Esc
Calib. Outp. Press. A
Cal. factor
OK
output signal 094.7 mV