ViscoTec flowscreen, Руководство по эксплуатации

Страница: 12 / 24

flowscreen
Operating Instructions
12 / 24 Version 1.0 Copyright ©
3.4.3 Defining sensors and connections
• < Settings > < Sensor X Selection / Calibration >
Select Channel
Pin allocation in the sensor cable plug (see 3.11). Factory setting is Pin 2 .
3.4.4 Calibrating the sensors
• < Settings > < Sensor X Selection / Calibration >
Calibration
The sensors are set ex-works with the values 0 bar ( Zero Value ) and 16 bar ( Full Scale ).
If other sensors are to be connected, these values must be adjusted according to the
manufacturer's information.
3.5 Base settings
3.5.1 Results / error messages
• < Settings > <Results>
< Error after x faults > = After this number of consecutive defective dosings (pressure value
outside of measuring range), the error LED illuminates red.
3.5.2 Start and end of the measurement
• < Settings > < Sensor X Selection / Calibration >
Measurement Start/End at
Selection:
Pressure Enter the pressure value that defines Start/End
Start/Stop-Signal Signal analysis (system plug (4))