ENG
9
VirtuFit Water Resistance Row 1000
HOW TO FILL AND EMPTY THE TANK
1. Remove the Fill Plug (49) from the Upper Tank Cover;
2. To fill tank with water, refer to Fig. A. Insert the Funnel (92) into the tank, then use a cup or the Pumping
siphon (91) and a bucket to fill the tank. Use the water level gauge on the side of the tank to measure
desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the Pumping siphon (91) to
pump out the water from the tank into the bucket.
4. Insert the Fill Plug (49) into the Upper Tank Cover. Wipe excess water off of the frame.
NOTE:
– Fill the tank only with tap water. Add 1 water-purification tablet (1 packet is included.). Never use pool
chlorine or chlorine bleach. This will damage the tank and void the warranty.
– Add a water purification tablet every 6 months or as needed. If water remains cloudy, replace the water
in the tank.
– Water from the tank is not suitable for consumption. Dispose the water after pumping it out from the
tank.
– See Fig. A. The water level gauge is on the side of the tank. The maximum fill is the top bar. Never fill it
over this limit. Filling the tank over this limit will void the warranty.
– The resistance depends on the water level in the tank. Water level 1 is the lowest resistance. Level 6 is
a higher resistance.
WATER LEVEL
