24: Automatic operator selection
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
© Virtual Access 2018
GW1000 Series User Manual
Issue: 2.3
Page 242 of 463
When you have configured your settings, click Save & Apply.
24.2.11.1
Set multi-WAN operation
From the top menu, select Network -> Multi-Wan. The Multi-WAN page appears.
Figure 123: The multi-WAN page
In the Multi-WAN section click Add.
Web Field/UCI/Package Option
Description
Web: Enable
UCI: multiwan.config.enabled
Opt: enabled
Enables multiwan.
Select this option.
0
Disabled.
1
Enabled.
Web: Preempt
UCI: multiwan.config.preempt
Opt: pre-empt
Enables or disables pre-emption for multiwan. If enabled the
router will keep trying to connect to a higher priority interface
depending on timer set by ifup_retry_sec.
Leave this option unselected.
0
Disabled.
1
Enabled.
Web: Alternate Mode
UCI: multiwan.config.alt
Opt: alt
Enables or disables alternate mode for multiwan. If enabled the
router will use an alternate interface after reboot.
Leave this option unselected.
0
Disabled.
1
Enabled.
Table 80: Information table for multi-WAN operation
24.3
Configuring via UCI
24.3.1
PMP + roaming: pre-empt enabled & disabled via UCI
24.3.1.1
PMP interface configuration
The PMP interface is configured in the network package /etc/config/network. To view the
network configuration file, enter:
root@VA_router:~# uci export network
package network
config interface 'loopback'