1. For shipping purposes,
the UV lamp and sleeve
are shipped in a separate
cardboard box. Carefully
remove the UV lamp from
the shipping box being
careful not to touch the
“glass” portion with your
fingers. Insert the UV lamp
into the quartz sleeve and
chamber making sure the
connection end is inserted
last. Mount the disinfection system to the wall or cabinet.
2. If the disinfection system is to be hard plumbed, make sure you leave enough
clearance in front of the lamp connector to facilitate lamp service (a length
equal to the length of the unit should suffice).
3. This system is designed to install on the main cold water line. Install the
disinfection system before any branch lines. Mount the system to the wall
using the two mounting holes in the back of the disinfection system with
appropriate fastening devices. Various connection methods can be used to
connect the water source to the disinfection system, however union type
connectors are recommended.
4. Prior to connecting the power source, check all connections to ensure that
they are indeed secure, turn on water supply and check for any leaks. If
satisfied that there are no leaks, proceed with the following steps.
5. Push lamp plug onto end of lamp.
6. Attach ground (green/yellow) and relief (red) wires from lamp. Plug to the
ground lug on the chamber. Secure both wires with locking screw provided.
7. The power source provided with your disinfection system must be located
within (5) feet of an electrical outlet. DO NOT USE AN OUTLET THAT CAN
BE SWITCHED OFF (IE. A WASTE DISPOSAL OUTLET).
5
1
2
Insert Lamp/
sleeve assembly
and screw into
chamber.
Caution: Over
tightening will
break the sleeve.
Note: If ballast enters alarm condition, power must be unplugged for several seconds to
allow ballast to reset.
Note: As the system requires time to reach its full operating capacity,please allow the
disinfection system to operate 3 - 5 minutes prior to using the water from the unit. In
addition, to clear any air or debris from the system, open the faucet and allow water to
run through the disinfection system for 2 - 3 minutes.
6
SLEEVE CLEANING AND LAMP REPLACEMENT
1. Turn off the shut-off valve situated by the inlet of the drinking water system.
2. Open a tap downstream of the UV system to release pressure.
Then, close this tap.
3. Turn off the shut-off valve situated by the outlet of the drinking water system.
4. Disconnect the power.
5. Let the system cool down for 10 minutes.
6. Squeeze sides opposite of tabs to remove cover. The strain relief wire should
remain connected.
1
2
7. Hold the sleeve
bolt to remove
lamp/sleeve
assembly (first
twist, then pull).
8.
For sleeve cleaning only:
Skip to step 14.
Note: Sleeve must be replaced if it
cannot be completely cleaned or if
it appears scratched or cracked.
For lamp or sleeve replacement:
Clean sleeve and follow steps
10-13.
9.
Sleeve
bolt
Lamp
tab
1
10. Remove o-rings and sleeve bolt
from sleeve.