Viper 50000569, Быстрый старт

Страница: 19 / 429

QUICK START GUIDE ENGLISH
16
Recovery water tank emptying
1.
Stop the machine.
2.
Lift the brush/pad-holder deck (25, Figure 1) by pressing the one-button
start (49, Figure 3) or restart the machine by Ignition key (42, Figure 3).
3.
Lift the squeegee (11, Figure 1) with the squeegee lifting/lowering
handle (39, Figure 2).
4.
Drive the machine to the appointed disposal area.
5.
Empty the recovery water tank with the hose (A, Figure 17). Then, rinse
the tank (B, Figure 16) with clean water.
Solution/clean water tank emptying
1.
Empty the solution tank with the outlet cover (A, Figure 18). After
working, rinse the tank with clean water.
AFTER USING THE MACHINE
After working, before leaving the machine:
1.
Remove the brushes/pad-holders by pressing the release button (44,
Figure 3) and clean them (only for disc machine).
2.
Remove the splash guard as (E, Figure 19) and cleaning it. (only for disc
machine)
3.
Remove the Pad and clean it. (only for orbital machine)
4.
Empty the tanks (B and C, Figure 18) as shown in the previous
paragraph.
5.
Perform the daily maintenance procedures (see the Maintenance
chapter).
6.
Store the machine in a clean and dry place, with the brushes/ pad-holders
and the squeegee lifted or removed.
CAUTION!
When draining the wastewater, the vacuum tube for
waste must be folded (A, Figure 17) and lowered to a
lower position (B, Figure 17), and then open the lid of
the vacuum tube for waste to drain the water. Do not
make the outlet of the vacuum tube for waste face up-
ward to drain the water vertically. This is to avoid
wastewater spilling onto the operator.
Figure 18
Figure 17
Figure 19
E
A
C
D
B