Valet
®
Mode
You can prevent your system from automatically arming and triggering
by using Valet Mode. This is very useful when washing the vehicle or
having it serviced. In Valet Mode, the system will not arm, even with the
transmitter, but all convenience functions (door locks, trunk release, etc.)
will work normally.
To enter or exit Valet Mode with the Valet switch:
Using Remote Valet Mode as you enter or exit the vehicle:
•
Open any door.
•
Press Button I (or the arm/disarm button).
•
Press Button II (or the function 2 button).
•
Press Button I again.
The Status LED will light steady if you have entered Valet Mode, and it
will go out if you exited Valet Mode.
Nuisance Prevention
®
Circuitry
Your system has DEI’s Nuisance Prevention® Circuitry (NPC
TM
). It
prevents annoying repetitive trigger sequences due to faulty door pin
switches or environmental conditions such as thunder, jackhammers,
airport noise, etc.
Here’s how it works: Let’s say the alarm triggers three times. Each time,
the same sensor or switch is triggering the alarm. The three triggers are
within 60 minutes of each other. NPC
TM
(Nuisance Prevention® Circuitry)
will interpret this pattern of triggers as false alarms. After the third trigger,
NPC ignores, or bypasses, that sensor or switch (along with any other
sensors or switches sharing the same zone).
Turn ignition to “run” position, then turn to
“off ” position. Press and release the Valet
switch within 10 seconds. The Status LED will
light steady if you have entered Valet Mode,
and it will go out if you exited Valet Mode.
-8-
