VIPA TD 03, Руководство пользователя

Страница: 39 / 54

Manual VIPA HMI Chapter 2 Deployment TD 03
HB116E - TD03 - Rev. 07/50 2-23
to 0. Connect the COM interface of the PC and the MP
2
I jack of your
TD 03 via the Green Cable.
to 1. Type the COM interface (you should not alter the setup)
to 2.
Turn off the power supply of your TD 03, push the key and
turn on the power supply again.
Now the TD 03 is ready for the firmware update. Nothing is shown
on the display.
to 3.
Click on in the updater.
to 4. A connection to the TD 03 is established and shown via the
message [connected].
If an error message appears instead, repeat the steps above with
another COM interface.
to 5.
At error free connection click on . Your TD 03 is
now prepared for data transfer.
to 6.
A click on opens a file selection window. Choose
the according firmware and start the download with .
If the error message "The selected file doesn't fit to your
hardware" appears you may have been tried to download a
firmware that is not compatible to your TD 03. With a valid
firmware version, the update process starts. This process may last
several minutes and is shown in a process bar.
After the download, the following window should appear:
to 7. Turn off the power supply of your TD 03, disconnect the Green
Cable, connect the TD with the CPU and turn on the power supply
again.
Now the TD 03 is ready with the new firmware.
If your TD 03 does not start anymore, an error occurred during the
firmware update.
Please call in this case the VIPA hotline.
Firmware update
via Green Cable
and cpu_up.exe