VIPA SLIO IM 053-1DN00, Руководство пользователя

Страница: 44 / 44

Chapter 3 Deployment Manual VIPA System SLIO
3-10 HB300E - IM - RE_053-1DN00 - Rev. 11/21
Status indication - Diagnostics
The LEDs, which are installed to display the status, allow extensive
diagnostics during the PowerON-procedure as well as during operation.
The result of the diagnosis is determined by the combination of the
different LEDs and the current operating mode.
Here the RD LED corresponds to the System SLIO backplane bus and the
MT LED to the DeviceNet bus.
SF RD MT Meaning
1 0 0 Setting on the address switch is not valid
0 1 0 The transfer rate was successfully stored
B B B Firmware update running
1 1 1 Firmware update finished successfully
E 1 1 Firmware update finished with error
- Error in EDS file
- Transfer error
- Error in flash
X X 0 Field bus is offline
- no DC 24V on the connector
- no further station on the field bus
X X B Field bus ready
- no connection established
X X 1 Field bus connected
1 X 0 Error field bus
- field bus address just exists
- communication error on the field bus
1 X B Inactivity
- connection disconnected due to inactivity
X B X System SLIO bus ready, outputs inactive
X 1 X System SLIO bus active
1 E X Error on access the System SLIO bus
E E X Configuration error System SLIO bus
- The number of real modules at the bus differs to the
configured modules.
- The module type of at least one module differs to the
type of the configured module.
B E E Device error / internal error
Please contact the VIPA support!
on:
● off: ○ not relevant: X
Blinking code B at a period duration of 1s: ○○●●
Blinking code E (Error) at a period duration of 2s: ○○○○○●○●
General
LED indication