Vip2 VK2 -600PTZ, Конфигурация и руководство пользователя

Страница: 60 / 80

54
VK2-600PTZ User manual
NOTE: The 200 seconds can be used per Pattern. Each movement uses memory to store the
change
– the % column show much of the total pattern memory has been used for each
tour and also gives the running total at the bottom. The Pattern memory does not have to
be evenly distributed across all of the Patterns.
4.8 Area Title
Enter a specific name on a programmed angle between START and END. E.g. For the screen
below, when the camera points at an angle between 124.3

(PAN), 30.7

(TILT) to 359.5

(PAN),
45.4

(TILT), ABC will be displayed on the screen.
AREA TITLE SETUP
NUMBER : 01
TITLE : ABC
START ANGLE : 124.3 30.7
END ANGLE : 359.5 45.4
SWAP : OFF
SAVE AND EXIT(ESC TO CANCEL)
NUMBER : 01-08
TITLE : up to 12 characters.
SWAP : Swap the start point for the end point.
Follow steps below to program the Area Title:
1.
Select ‘NUMBER’ and set the desired number by moving the
Joystick to the left or right.
2.
Select ‘TITLE’ – this can be changed one of two ways:

Moving the Joystick left and right to select the cursor location and (TELE/WIDE) to
change the character

Use the Joystick to move and navigate the cursor to the alpha numeric character
table displayed and select the required character with the (IO/FN) keys
3.
Select ‘START ANGLE’. Press the
(IO/FN) key,
then ‘CTRL’ is displayed. Move to the desired
position. Press the (IC/FF) key
then ‘CTRL’ disappears. To adjust at the 0.1 degree interval,
twist the Joystick at the pan field and the tilt field.
4. Select ‘END ANGLE’. Press the
(IO/FN) key,
then ‘CTRL’ is displayed. Move to the desired
position. Press the (IC/FF) key
then ‘CTRL’ disappears. To adjust at the 0.1 degree interval,
twist the Joystick at the pan field and the tilt field.
5. Select
‘SWAP’. Set to ON, to swap the start angle and the end angle - adjust with
(TELE/WIDE)
6.
To save changes highlight ‘SAVE AND EXIT’ and move
Joystick right. Joystick left exits
without saving.