Vip2 VK2 -600PTZ, Конфигурация и руководство пользователя

Страница: 11 / 80

5
VK2-600PTZ User manual
2.4 Setting Dome Camera Address (ID)
To prevent damage, each dome camera must have a unique address (ID).
When installing multiple dome cameras using a multiplexer, it is suggested that the dome camera
address match the multiplexer port number.
The factory default setting is 1.
Refer to
‘4.13 Dome Communication’ section for detailed information.
2.5 Connections
• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of VK2-600PTZ. Generally a cross-over
cable is used for directly connection to PC, while a direct cable is used for connection to a hub.
• Connecting Alarms
AI (Alarm In)
You can use external devices to signal VK2-600PTZ to react on events. Mechanical or electrical
switches can be wired to the AI (Alarm In) and G (Ground) connectors.
Please s
ee “3.5.4 Event > 1) Event-In >
②
Alarm In” for configuring alarm input.
G (Ground)
NOTE: All the connectors marked G or GND are common.
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.
AO (Alarm Output)
VK2-600PTZ can activate external devices such as buzzers or lights. Connect the device to the
AO (Alarm Out) and G (Ground) connectors.
Please s
ee “3.5.4 Event > 2) Event-Out >
④
Alarm Out” for configuring alarm output.
• Connecting to the RS485
VK2-600PTZ can be controlled remotely by an external device or control system, such as a
control keyboard, using RS485 half-duplex serial communications signals.
• Connecting Video out connector
Connect the video out (BNC) connector to the monitor or video input.
• Connecting the Power
Connect the power of 12VDC 1.5A for VK2-600PTZ.
When using a 12V
DC adapter, connector the po) pole to the ‘+’ position and the
negative(-
) pole to the ‘-‘ position.
Use satisfy clause 2.5 of IEC60950-1/UL60950-1 or Certified/Listed Class 2 power source only.