VIO 7 Vio, Инструкция по эксплуатации

Страница: 11 / 34

11
Rev. 1 20.12.2019
EN

LED
All the instruments are equipped with a two-colours LED (red and green) which provide the user with
important information on the status of the system:
Function LED Description
Power on Fixed
Power off Fixed
Standby Flashing every 20 s
Measure stable Flashing every 3 s
Errors during calibration Flashing every 1 s
Errors during measurement Flashing every 3 s
Selection confirm Switched on for 1 s
Timed screens Fixed
DHS deactivation Fixed
Installation

Components supplied
The instrument is always supplied inside the specific transport case; in the version without sensor it
is always present:
Instrument with batteries, 1m S7 / BNC connection cable, NT55 temperature probe, buffer solutions in
single-dose bottle and / or sachet, paper tissues, screwdriver, beaker, electrode holder support -only for
multiparameter- multilingual user manual and test report.
Versions with the sensors(s) already included are also available. Contact your local distributor to be updated
on the correct composition of the sales kit.

Implementation

The device leaves the factory ready to be used by end-user.

Batteries are included.

Turning On and Off
Turn on the system by pressing the button . The display initially activates all segments and then
appears:

model and firmware of the instrument;

settings relating to the most important parameters and any information on the DHS sensor, if connected;

the instrument switches on to the last parameter that was used;

to switch off the instrument, press the key , while into measure mode.