POV.HD User Manual
Get Ready
7
b.
When the recorder powers up, the LCD displays the message “No camera detected”
•
The camera head cable may not be connected or it may not be seated properly. If the camera
head appears to be attached, remove the cable completely, and try connecting again.
•
If you press the power up button and release it quickly (before the LED changes to red) the
recorder will not power up. If you then press and hold the power button and start a normal power
up, the recorder may fail to detect the camera head. In this case a message will be displayed
instructing you to power down the recorder by pressing the Power button, wait five seconds , and
then power up again. This should correct the previous error condition.
c.
The camera comes up correctly, but no image is displayed on the LCD.
•
Check to see that the camera head view isn’t blocked. If it’s under or behind something, or you
stuck it in your pocket, there may be nothing to see.
•
Disconnect the camera cable and check to see that all the pins in the camera head cable
connector are straight and evenly spaced. Then reconnect the cable. It is not necessary to power
down the recorder to disconnect and reconnect the camera head.
Set the System Time and Date
The time and date must be set in the recorder (one time only) so that video clips, still photos, and other files
will be correctly labeled.
1.
Press the
Settings
button to go to the settings.
2.
Navigate to
Time and Date
using the
<<
and
>>
soft keys.
3.
When you reach the
Time and Date
menu, press the
Select
soft key.
4.
The time and date are set one digit at a time. The
^
soft key increments the current digit (colored red),
and wraps at 9 to begin again at 0. The
>
soft key moves to the next digit to the right, and wraps to the
beginning after the last digit.
5.
When the time and date are correct, press the
Save
soft key to store the time and date.
6.
Press
Play
to enter
Play-‐Preview
mode
.
“Play” is displayed in the upper left of the LCD.
NOTE
: The system time and date will be cleared and you will need to set the time and date again using this
procedure, if:
•
You do not power down the recorder before removing the batteries, or
•
You remove the batteries and do not replace them within 1 hour.
Check the wireless remote
1.
If the recorder is not in Record Standby mode (“Standby” displayed in the upper left of the LCD), press
REC
on the recorder to go to Record Standby mode..)
2.
With the recorder powered up and in Standby, and with the wireless remote within 5 feet of the
recorder, press
REC/TAG
on the remote.
3.
The recorder should start recording. The word “Clip” will appear in the upper left corner of the LCD,
the upper right corner will be counting up the seconds that indicate the length of the recording, and
the LCD will show what is being recorded.
4.
Press
STOP
on the wireless remote.
5.
The recorder should stop recording and return to Standby.
