Vision blue pan and tilt head
12
0QFSBUJPO
Fitting the pan bar
A single pan bar is supplied and is fitted to either the right or left-hand side of the head onto the
pan bar mounting (16).
To fit the pan bar:
Position the pan bar (8) onto the pan bar mounting (16).
Rotate the pan bar clamp (7) in a clockwise direction until the pan bar is secured.
A second pan bar can be fitted to the other side of the head if required.
*OTUBMMJOHUIFIFBEPOBUSJQPE
The Vision blue pan and tilt head is supplied with an integral 75 mm ball mount, designed for
installation on a compatible Vinten Vision tripod. Adaptors are available which enable the head
to be installed on tripods fitted with other mountings.
To install the head onto the tripod:
Remove the bowl clamp assembly (14) from the head by turning the assembly in a
counter-clockwise direction.
Position the head on the tripod, carefully lowering the head into the tripod bowl.
Using the pan bar to steady the head, refit the bowl clamp assembly (14) from below the
tripod bowl, turning the bowl clamp assembly (14) in an clockwise direction until the
head is held in position.
Apply the pan brake (4) and tilt brake (3) by turning the levers in a clockwise direction.
Level the head using the level bubble (15) and once level, tighten the bowl clamp
assembly (14) to secure the head in position. When attempting to level the head in
situations where there is low light, the level bubble can be illuminated by pressing the
push button (12) located on the rear of the head beneath the Perfect Balance knob (11).
The light will extinguish after approximately 15 seconds.
.PVOUJOHUIFDBNFSB
The head is supplied with a camera slide plate (2) fitted with a 1/4 in. pin assembly (1),
comprising a locating pin on a plate and a 1/4 in. camera mounting screw.
To mount the camera onto the head:
Remove the slide plate (2) from the head. Release the slide plate clamp (6) and press
the slide lock release (17), then slide the plate out to the rear of the platform (9).
CAUTION!
DO NOT use force on the brake levers. Hand tighten only.