Vinteck
TB10MKII – TB5 –True-bypass MIDI pedalboard
pag.9
Edizione 02 rev.1
Example 3
Chain of 10 pedals. % in front of amp, 5 in send/return. Tuner in B out for silent tunings. Volume in buffer
out/return.
6- PROGRAMMING
DISPLAY OF PROGRAMS
Number of avalable programs is 120.
Backs of programs are in blocks of 5. 1-5, 6-10, 11-15 ... 95-100
The3 digit display show the programma on while. 1-100.
Duringthe bank change digits flash showing the corrispondenced number of upper or lower bank (es.11 UP
shows 16, then 21 etc.) until when one program button is pressed (in ex 7 for 27).
If using up and down you come back to origina bank the display stops to flash.
When in programming mode the 3 dots of display will appare.
FACTORY PRESET
No factory preset are programmed.
DIRECT ACTIVATION OF LOOPS
Each loop is activeted by his corrisponded button.
When a button is pressed the loop is activated.
When pressed again the loopi is deactivated.
PROGRAMMING LOOPS COMBINATION
To program a combination of loops and switches, corresponding to a MIDI program change,
choose with UP or DOWN the desired bank (ex. 1-5 or 10-15).
Then press the program button (ex. Program 12 press button 2) andkepir pressed for 3 seconds.
On display the 3 dots of digits will be on. Now the unit is in programming mode.
Press now the buttons of loops to be inserted in the program (ex. 1 – 3 – 7)
Press again the same program button and the memorization is completed.
If any ather buttom is pressed instead of the program used to began the programming sequence the program
will be not memorized.
Inside of a program,when recalled, it is possible in any moment to actbate or deactivate any loops.
