9
www.vintageair.com
905701 REV B 09/18/18, PG 9 OF 34
Passenger Compartment
Disassembly (Cont.)
6. To remove the heater assembly and the OEM defrost duct, perform the following:
A. Remove the screw behind the distributor in the engine compartment. NOTE: To gain access to the
screw, removal of the distributor cap may be required (See Photo 6, below).
B. Remove the (2) screws on the outside of the blower housing opening (See Photo 7, below).
C. In the passenger compartment, under the dash, remove the (4) screws on the heater assembly cover
(See Photo 8, below).
D. Remove the (2) screws securing the OEM defrost duct to the dash (See Photo 9, below). Disconnect the
wiring, and remove the screw securing the cable to the defrost duct (See Photo 10, below).
E.
Remove the (3) screws securing the fresh air vent cover to the firewall (See Photo 11, below).
Photo 6
Photo 7
Photo 8
Photo 9
Photo 10
Photo 11
Remove
Screw
OEM Defrost
Duct
OEM Defrost
Duct
Remove (3)
Screws
Fresh Air
Vent Cover
Heater Assembly
Cover
Remove (2)
Screws
Disconnect
Wiring
Blower Housing
Opening
Remove (2)
Screws
Remove
Screw
Cable
Engine Compartment
View
Engine Compartment
View
Distributor
Remove
(4) Screws
