6
www.vintageair.com
905701 REV B 09/18/18, PG 6 OF 34
Engine Compartment Disassembly
1.
2.
3.
4.
5.
6.
Remove the hood by removing (4) hood hinge bolts (retain) (See Photo 2, below).
Remove the passenger side hood hinge by removing (4) bolts ((2) bolts from under the dash inside the
passenger compartment and (2) in the engine compartment) (See Photos 3 & 4, below).
Disconnect and remove the battery.
Remove the battery tray by removing (4) bolts (See Photos 5 & 6, below).
Remove the air cleaner (See Photo 7, below).
Drain the radiator, and remove the upper and lower hoses.
NOTE: Before starting the installation, check the function of the vehicle (horn, lights, etc.) for proper
operation, and study the instructions, illustrations, & diagrams. Retain OEM bolts, washers and nuts
(unless otherwise indicated), as some hardware will be reused. When the installation is complete,
make sure all holes through the firewall are sealed to prevent water intrusion, and be sure the
windshield wiper escutcheon is sealed. Any water damage to the evaporator system may void the
warranty.
Perform the Following:
NOTE: Vintage Air recommends the removal of the hood for easier installation. Before removing the
hood, mark where the hood and hinge meet with a pencil (See Photo 1, below). This will help during
reassembly.
Photo 1
Photo 2
Photo 5
Photo 4
Photo 3
Photo 6
Photo 7
Mark Where the Hood
and Hinge Meet
Remove (4) Hood
Hinge Bolts
Remove (2)
Bolts
Remove (2)
Bolts
Remove (2)
Bolts
Remove (2) Bolts
to Detach
Battery Tray
Under Dash,
Passenger
Compartment
Remove
Air Cleaner
Engine
Compartment
