17
901142 REV D 5/16/17, INST 63-66 CORVETTE EVAP wo AC PG 17 OF 25
INSTALL DUCT HOSES AS SHOWN IN FIGURE 20, PAGE 18.
ROUTE A/C WIRES THROUGH 3/8” GROMMET AS SHOWN IN FIGURE 19 BELOW.
(12 VOLT/ GROUND/ BINARY SWITCH/ HEATER VALVE).
PLUG THE WIRING HARNESS IN THE ECU MODULE ON SUB CASE AS SHOWN IN FIGURE 20, PAGE 18
(WIRE ACCORDING TO WIRING DIAGRAM ON PAGE 19 AND 20.)
INSTALL (9) #8 U-NUTS IN GLOVE BOX AS SHOWN IN FIGURE 19a.
INSTALL NEW GLOVE BOX USING OEM SCREWS.
REINSTALL CENTER FLOOR CONSOLE.
REINSTALL KICK PANEL.
RELOCATE OEM DRIVER SIDE FRESH AIR CABLE ASSEMBLY TO OEM PASSENGER SIDE MOUNTING
LOCATION SEE FIGURE 19 BELOW.
REINSTALL ALL PREVIOUSLY REMOVED ITEMS.
FILL RADIATOR WITH AT LEAST A 50/50 MIXTURE OF APPROVED ANTIFREEZE AND DISTILLED WATER. IT IS THE
OWNER'S RESPONSIBILITY TO KEEP THE FREEZE PROTECTION AT THE PROPER LEVEL FOR THE CLIMATE IN
WHICH THE VEHICLE IS OPERATED. FAILURE TO FOLLOW ANTIFREEZE RECOMMENDATIONS WILL CAUSE
HEATER CORE TO CORRODE PREMATURELY AND POSSIBLY BURST IN AC MODE AND/OR FREEZING WEATHER,
VOIDING YOUR WARRANTY.
DOUBLE CHECK ALL FITTINGS, BRACKETS AND BELTS FOR TIGHTNESS.
VINTAGE AIR RECOMMENDS THAT ALL AC SYSTEMS BE SERVICED BY A CERTIFIED AUTOMOTIVE AIR
CONDITIONING TECHNICIAN.
EVACUATE THE SYSTEM FOR A MINIMUM OF 45 MINUTES PRIOR TO CHARGING AND LEAK CHECK PRIOR
TO SERVICING.
CHARGE THE SYSTEM TO THE CAPACITIES STATED ON THE INFORMATION PAGE (PAGE 4) OF THIS
INSTRUCTION MANUAL.
SEE OPERATION OF CONTROLS PROCEDURES ON PAGE 21.
FINAL STEPS
FIGURE 19b
FIGURE 19
FIGURE 19a
3/8” GROMMET
33144-VUI
OEM DRIVER SIDE
FRESH AIR CABLE
ASSEMBLY
(9) #8 U-NUTS
189801
INSTALL POWER ANTENNA SWITCH (65 AND 66 VETTE ONLY) REFER TO PAGE 24.
INSTALL CONTROL SWITCHES AND WIRING. (SEE CONTROL PANEL INSTRUCTIONS)
INSTALL DRIVER AND PASSENGER SIDE CONSOLE PANELS USING OEM SCREWS AS SHOWN BELOW IN
FIGURE 18.
NOTE:
LOWER MOUNTING HOLE MUST BE DRILLED IN OEM CONSOLE TO MOUNT NEW
CONSOLE. USE DRIVER/ PASSENGER CONSOLE PANEL AS GUIDE TO DRILL 3/16” HOLE IN CONSOLE.
RELOCATE OEM J NUT AND ATTACH AS SHOWN.
DRIVER & PASSENGER SIDE CONSOLE PANEL INSTALLATION
DR SIDE
CONSOLE PANEL
491632
OEM
SCREWS
DRILL
3/16”
OEM
CONSOLE
OEM
HOLE
OEM
HOLE
PASS SIDE
CONSOLE PANEL
491633
OEM
SCREWS
DRILL
3/16”
OEM
HOLE
OEM
HOLE
FIGURE 18
