13
7 3 2 S o u t h R a c e t r a c k R o a d , H e n d e r s o n , N e v a d a 8 9 0 1 5
i n f o @ v i n o t e m p . c o m
PROBLEMS WITH YOUR WINE COOLER
Most common problems can be solved easily, saving you the cost of a possible service call. Try the following
suggestions to see if you can solve the problem before contacting Vinotemp at [email protected].
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
Wine Cooler does not operate
•
Ensure unit is plugged in to electrical outlet.
•
Check if unit is turned off.
•
Check for a tripped circuit breaker or blown fuse.
Wine Cooler is not cold
enough
•
Check the temperature control setting.
•
External environment or ambient temperature may require a higher
setting.
•
Check if door does not close completely or is open too often.
•
Check if door gasket does not seal properly.
Wine Cooler turns on and off
frequently
•
The room temperature may be hotter than normal.
•
Check if door does not close completely or is open too often.
•
Check if door gasket does not seal properly.
•
The temperature control is not set correctly.
Wine Cooler light does not
work
•
Ensure unit is properly plugged in.
•
Check for a tripped circuit breaker or blown fuse.
•
Check if the light switch is OFF.
Wine Cooler makes too much
noise or vibrates
•
Check to ensure the unit is level.
•
The rattling noise may come from the flow of refrigerant. This is
normal.
•
As each cycle ends, you may hear gurgling sounds caused by the
flow of refrigerant in the unit. This is normal.
•
Contraction and expansion of the inside walls may cause popping
and crackling noises.
Wine Cooler door will not
close properly
•
Check to ensure the unit is level.
•
The door was reversed and was not properly installed.
•
The gasket is dirty.
•
The shelves are out of position.
Display shows “EL” or “EH”
•
The air temperature sensor in the corresponding temperature zone
has failed.
The inside of the wine cooler
has a strong odor
•
Unplug the unit and remove all contents. Clean the interior of the
wine cooler following the instructions listed under Care &
Maintenance. Leave the unit unplugged with the door open for 24
hours before plugging it back in.
