8
8
W W W . V I N O T E M P . C O M
INSTALLATION
•
Remove all packing material before using your wine cooler.
•
Clean the interior surface with lukewarm water and a soft cloth.
•
IMPORTANT
: Before connecting the unit to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation. We also recommend leaving the door of the unit open during this time to allow the interior
of the unit to air out.
•
This unit is designed for freestanding or built in installation but indoor use only. Position the unit in a dry
and well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 60°F.
•
For built-in installation, leave a ¼” (6.35mm) space on each side and at the top of the wine cooler to
ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct the
front exhaust vent with any objects as this may affect the unit from performing properly.
•
For freestanding installation, 6” of space at the back, 10-12” of space on each side, and unlimited
clearance at the top of the wine cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this
will not allow for proper air circulation.
•
Do not slide the unit into place.
•
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level the
wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
•
For best performance it is recommended that you install the appliance in a location with an ambient
temperature between 72°-78°F. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
•
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
REVERSING THE DOOR SWING OF YOUR APPLIANCE
This unit has the capability of the door opening from either the left or right side. The unit is delivered to you
with the door opening from the left side. Should you desire to reverse the direction in which the door opens,
please follow these instructions:
NOTE:
All parts removed must be saved to allow the door swing to be reversed.
•
Open the glass door and remove the two lock screws
②
holding the door shaft assembly
③
to the
glass door. Be careful to hold the glass door firmly after removing the screws. (Fig. 1)
•
Pull down to remove the glass door and place it on a padded surface to prevent scratching it.
•
Remove the two screws from the door bottom at left side and install them to the door bottom at right
side. (Fig. 3)
•
Remove the lower door hinge
①
and turn around 90°, then install it at the designated position on the
left side. And install the door shaft assembly
③
accordingly. (Fig. 2)
•
Remove the upper hinge cover
④
and remove the four screws
⑤
that are used to fix the upper hinge
⑥
to the cabinet top. Then remove the upper hinge and install it at the designated position on the left
side. (Fig. 4)
•
Set the glass door into the designated position, and install the two lock screws
②
to connect the door
shaft assembly
③
with the glass door and tighten them before the door is leveled. (Fig. 5)
•
Remove the handle from the left side of the door and install it on the right side.
