VINCENT SP-T100, Инструкция по эксплуатации

Страница: 27 / 48

Vincent
27
CONNECTION OF THE LOUDSPEAKERS
If no connector is to be used, remove approximately 1 cm length of insulation from each end of the spea-
ker wire. Twist the braid in order to avoid short circuits. Turn the fastener on the loudspeaker terminal coun-
ter clockwise to loosen it and introduce the bare wire end into the exposed connector hole. Then turn the
fastener clockwise so that the wire is firmly clamped. Make sure the connection is pretty tight.
Attention:
All loudspeakers must have a nominal impedance of at least 4
Ω
.
Respect correct polarity, the positive contact is mostly marked red or with “+”. The side of the speaker
cable that has to be connected with the positive socket has a marking.