VINCENT SP-T100, Инструкция по эксплуатации

Страница: 24 / 48

24
Vincent
CONNECTING THE PREAMPLIFIER
This main amplifier is equipped with a mono audio input (“LINE IN”) on which the unit awaits the preampli-
fied signal of an audio channel. This is the audio information that the SP-T100 provides for one or two loud-
speakers.
Attention:
No source with a standard line level signal (“LINE OUT”) must be connected to this input. It is only
intended for preamplified signals (e.g. “PRE OUT”).
This audio input connector must be interconnected to the output connector (“PRE OUTPUT” or “OUTPUT”)
of a preamplifier. If the SP-T100 is to supply one channel of a stereo system, connect the input connector
of the SP-T100 with a preamplifier output socket that is usually labelled “PRE OUT R” or “PRE OUT L”.
SP-T100
Preamplifier
RCA connection
1 2
O U T P U T
BALANCE
If the SP-T100 is used in a multi-channel system, then the connection socket of the desired channel (e. g.
“FRONT R”) in the connection field of the decoder preamplifier usually marked with “AUDIO OUTPUT” is
to be connected to the input of this main amplifier.
Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device (7). Connect the other end of the mains cable to a mains socket.
CONNECTION OF THE POWER CABLE