VINCENT SP-T100, Инструкция по эксплуатации

Страница: 22 / 48

22
Vincent
4. LINE IN: Input for preamplified
mono audio signal
This input must be connected with the output connec-
tor of the preamplifier for the desired channel. For
example, with “PRE OUT R”, if the SP-T100 is to be
used for the loudspeaker of the right-hand stereo
channel. Do not connect any line level sources!
5. DIMMER:
Dimmer for the tube illumination
The setting of this switch affects the brightness of
the illumination of the tube display window (1).
6. SPEAKER A/B: Loudspeaker terminals
At these output sockets with threaded terminals
one or two loudspeakers can be connected.
Speaker cable with 4 mm banana plugs can be
used. Please take note of the information given in
the section “Installation”, if two loudspeakers will
be connected to the amplifier.
7. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to the AC
wall outlet. The small plastic housing beneath the
plug opening holds the fuse. Refer to the security
precautions.
REAR VIEW
6 6 7
4
5