Vimar Elvox RS10, Инструкция по установке и эксплуатации

Страница: 23 / 100

21
RS10
3 . 6 C onnecting ph otocells:
Normally closed contact (when the photocells are not engaged the PHOTO LED must be on), when this input trips during closing it reverses the move-
ment, if not used then jumper between COM. and PHOTO, you must observe the polarity of the power supply for the photocells:
Fig. 9
3 . 7 Sensitiv e edge connection
Programmable input (with edge or photocell not engaged the STPA LED must be ON). if this input trips during opening it immediately reverses the move-
ment for 1.5 seconds and then stops the gate, while during closure it reverses the movement until fully open, see the parameter P06 to select the type
of edge. If not used, jumper between COM. and STPA and set the parameter P06 OFF.
Fig. 10
Sw itch edge connection Relativ e sensitiv e edge connection
STPA input as edge with electromechanical
switch, set parameter P06 OFF. STPA input as resistive edge at 8.2Kohm,
set parameter P06 ON
3 . 8 E lectrical connection w ith ph oto-test f unction activ e:
with parameter P08 on 1, the control unit governs the operation of the photocells
connected on the PHOTO input, with parameter P08 on 2 the control unit governs the operation of the photocells connected on the STPA input, with
parameter P08 on 3 the control unit governs the operation of the photocells connected on the PHOTO and STPA inputs. Figure 10 shows an example
of a connection with photo-test on only for the PHOTO input.
Fig. 11
EN
+
-
COM
FOT
O
+
-
2CAN COM
FOT
O
STP
A
17 18 19 20 21 22 23
COM COM
ST
PA
ST
PA
8,2 K
Ω
17 18 19 20 21 22 23
CN1 CN2
RX1
+ - C NC NA + -
RX2
+ - C NC NA
+ -
+
STPA
FOT
-
TX1 TX2
COM
17 18 19 20 21 22 23
RX1
CN1 CN2
+ - C NC NA + -
RX2
+ - C NC NA
+ -
+
COM
FOT
--
TX1 TX2
17 18 19 20 21 22 23