Villager VLN SC 350, Оригинальное руководство пользователя

Страница: 33 / 95

15
MALFUNCTION POSSIBLE CAUSE REPAIR
No cutting
Comb plate inappropriately
installed
Adjust the upper blade 1.5mm
behind the comb plate (Figure
10).
Lever roller is missing (Figure 1,
Item 23)
Gear and/or reduction gear are
defective (Figure 1, Item 8)
Replace the gear
Shearing head worn (Figure 1,
Item 21).
Replacement needed
Shearing head extremely
warm
Clipping pressure too high Reduce the clipping pressure
No lubricating layer on the lever
roller (Figure 1, Item 23)
Lubricate the lever roller
No lubricant on the adjusting
knob (Figure 1, Item 6)
Lubricate the adjusting knob
Worn bearings Replacement needed
MALFUNCTION POSSIBLE CAUSE REPAIR
Motor not working
No power Check conductors and fuse
Defective cable
It should be inspected and
replaced by authorized service
center
Defective switch or motor
It should be repaired by
authorized service center
Motor runs very slowly
Carbon brush worn
Replace the carbon brush at
authorized service center
Defective rotor or stator Replace the rotor or stator
Motor unit heats up Air filter is blocked. The air is
unable to circulate (Figure 1, Item
26).
Remove the air filter and clean it
with a brush or replace the filter.
Clipping pressure too high
Do not overtighten the head for
adjustment of clipping pressure
(Figure 6 ). If the blades still don’t
cut, they should be replaced.
Defective bearings (cleaning
liquid has damaged the bearings) Replace the bearings.
Motor unit is very noisy
(whistling)
Reduction gear and shaft are not
lubricated.
Lubricate the reduction gear and
shaft.
Motor vibrates Rotor turns inadequately (caused
by sharp hit)
Replace the rotor.
Bearings are worn Replace the bearings.