© 2009 Viking Preferred Service
28
Interface/Induction Adapter
The interface receives a signal from the switch
depending on the consumer selection. This input
triggers a corresponding output to the generator
to power the inductor and induce energy into the
cooking vessel.
*IMPORTANT NOTE:
Interface
boards are pre-programmed for
specific inductor configurations. When
replacing interface boards be sure to
check the replacement part number
for the specific board needed or you
will get an interface error (Er31).
The interface is connected to the switch via a 5
wire cable. Ohm the wire to ensure no breaks and
verify connections are tight. If the cable is OK, verify
resistance of switch per information in component
testing chart. If connections are tight, wiring is
good, and switch resistance is in range,
replace the interface.*
Service Diagnostics and Procedures
7 Segment Display
Out to Filter Board
out to LED
Indicator Board
From
Induction Switch
VCCU
7 Segment Display
Out to Filter Board
out to LED
Indicator Board
out to LED
Indicator Board
From
Induction Switch
VICU
From
Induction Switch
