Viking Undercounter/Freestanding Refrigerated Drawer, Инструкция по использованию и установке

Страница: 9 / 24

9
FULL OVERLAY PANEL INSTALLATION
Step #1
1. A #10 pan head wood screw should be used to properly
secure the overlay panel. A total of 8 screws will be
needed.
2. Use only pan head screws.
3. Do not select a screw that is longer than the wood
thickness of the screw locations.
4. Use recommended pilot holes for the frame material.
(Use chart below.)
Gasket
5/16 Phillips Head Screws
Holding Drawer Front (8 total)
Step #2
R Re em mo ovve e D Drra aw we err F Frro on nttss
(Note: The overlay panel may be installed without removing the drawer fronts from the drawer bodies, but the full
drawer assembly is not as easy to handle as the drawer front alone.)
1. Remove drawer from unit. Begin by
pulling out the drawer. Locate the
drawer lock which can be found on the
outside of the cabinet slide (Figure 1).
Push the back of the drawer lock
forward and then down, releasing the
drawer from the cabinet slide (Figure 2).
Repeat this on the opposite side of the
drawer. Lift the drawer up from the
slides at 90
o to fully remove the drawer
from the cabinet (Figure 3).
2. Remove drawer fronts. Do this by
removing the 8 phillips screws and
washers securing the drawer front to
the drawer body. Mark lightly with an
erasable marker the position of the
stainless drawer liner where it is secured
to the stainless drawer before removing
screws.
3. Remove the gasket from the drawer
front. Do this by pulling the gasket out
of the channel that holds it to the
drawer front. This will expose the
clearance holes for mounting the
overlay panel.
P Piillo ott H Ho olle e D Drriillll S Siizze ess ffo orr W Wo oo od d S Sccrre ew wss
W Wo oo od d S Sccrre ew w S Siizze e # #1 10 0
W Wo orrkk M Ma atte erriia all
Pilot Hole Size
H Ha arrd dw wo oo od d
3/32
S So offttw wo oo od d 5/64
Figure 1 Figure 2
Figure 3