Viking Undercounter/Freestanding Refrigerated Drawer, Инструкция по использованию и установке

Страница: 10 / 24

10
FULL OVERLAY PANEL INSTALLATION (con’t)
Step #3
S Siizziin ng g tth he e O Ovve errlla ayy P Pa an ne ell
Step #4
A Atttta acch hiin ng g tth he e O Ovve errlla ayy P Pa an ne ell tto o tth he e D Do oo orr
1. Set the overlay panel on drawer front face and align edges. Clamp panel in position and mark pilot hole locations.
See Step #3 for nominal size and hole locations. Drill pilot holes (remove panel if necessary, re-align and re-clamp
overlay to drawer face.)
2. Insert wood screws through clearance holes and tighten to secure overlay panel.
3. Reinstall gasket into channel. Make sure the corners are inserted fully.
Step #5
R Re ea atttta acch h D Drra aw we err F Frro on ntt tto o D Drra aw we err B Bo od dyy
Align mounting holes on drawer body with mounting holes on drawer front. Align the door liner to the front flanges by
using the erasable marker alignment lines that were applied prior to removing the door from the drawer. Reinstall
phillips head screws and washers. Snug down, but do not tighten fully, final adjustment of drawer front will be done
after reinstalling the drawer.
Step #6
R Re eiin nsstta allll tth he e D Drra aw we err
1. Fully extend drawer slides and place drawer on slides. Be sure that drawer sits evenly on both sides.
2. Lock drawers into drawer slides. Push drawer locks down and then back to relock the drawer into the slide.
Step #7
A Ad djju usstt D Drra aw we err F Frro on ntt
1. Adjust drawer front to achieve a 1/8” gap from the top of the drawer front to the top of the cabinet or (for bottom
drawers) 1/8” from the top of the drawer front to the bottom of the top drawer, the drawer front should be centered
between the cabinet edges.
2. Fully tighten phillips head screws
23-5/8” (60.0 cm)
15-3/16”
(38.6 cm)
14-5/8”
(37.1 cm)
7-19/32”
(19.3 cm)
9/16”
(1.4 cm)
9/16” (1.4 cm)
11-13/16” (30.0 cm)
23-1/16” (58.6 cm)