Viking Undercounter/Freestanding Refrigerated Drawer, Инструкция по использованию и установке, Страница: 14 / 24

LED LIGHT REPLACEMENT
Never pour liquids directly onto light assembly.
ELECTRICAL SHOCK HAZARD
Failure to disconnect the power cord when changing
the light bulb may result in electrical shock.
INTERIOR LIGHT
1. Unplug unit.
2. Remove drawers. (This is not required to remove the light, but will provide better access). See Figures 1 through 3
in Full Overlay Panel Installation on page 6.
3. Remove old lights. Use 2 small, thin bladed screwdrivers or putty knives to press in the locking tabs on the lens
housing. (Figures 4 and 5). With the locking tabs depressed, pull downward (Figure 6), the light housing will pop
free. Disconnect the wire lead by pulling straight out from the connector. Connect wire lead to new light and re-
install into metal housing. The light will only fit in the housing with the locator tabs pointing to the front of the unit.
4. Re-install drawers.
5. Plug in unit.
Figure 4 Figure 5
Figure 6
14
CLEANING AND MAINTENANCE
Any piece of equipment works better and lasts longer when maintained properly and kept clean.
C
Co on nd de en nsse err
The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on
adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet.
Spiders and insects can nest in and around the refrigerated drawer causing damage to the unit. Frequently brush or vacuum
lint and dirt from the condenser coils for efficient performance by unscrewing the grill on the bottom front of cabinet.
C Ca ab biin ne ett
The cabinet can be washed with mild soap and water and thoroughly rinsed with clear water. Never use abrasive scouring
powders.
IIn ntte erriio orr
Wash interior compartment with mild soap and water. Do not use abrasive powder, solvent, polish cleaner or undiluted
detergent.
S Stta aiin nlle essss S Stte ee ell P Pa arrttss
All stainless steel parts should be wiped regularly with hot soapy water. Use a liquid cleaner designed for stainless steel when
soapy water will not do the job. D
Do o n no ott u usse e steel wool, abrasive cloths, cleansers, or powders. Do not permit citrus or tomato
juice to remain on stainless steel surfaces, as citric acid will permanently discolor stainless steel.
B Brra assss P Pa arrttss
C CA AU UT TIIO ON N:: All brass parts are coated with an epoxy coating. D DO O N NO OT T U US SE E B BR RA AS SS S O OR R A AB BR RA AS SIIV VE E C CL LE EA AN NE ER RS S O ON N T TH HE E
B BR RA AS SS S P PA AR RT TS S.. All brass parts should be wiped regularly with hot soapy water. When hot soapy water will not do the job,
use every day non-abrasive household cleaners.
WARNING
CAUTION