5
Mounting and Wiring the PSA-IP Paging Speaker Adapter
A. 8-Ohm Speaker Conversion
Step 1.
Disconnect existing speaker connections and
remove ceiling tile with speaker (suspended
ceiling) or remove speaker from drywall.
Step 2.
Magnetically attach the
PSA-IP
to the back of the
speaker magnet. Alternatively, the
PSA-IP
can be
attached to the 70V transformer mounting holes in
the speaker frame with provided screws.
Step 3.
Attach red and black wires from
PSA-IP
“Speaker” output to the speaker terminals.
Step 4.
Attach a Cat5 or higher cable to the
PSA-IP
LAN
w/POE port. See Typical Installation section for
details.
B. 25V or 70V Speaker Conversion
Step 1.
Remove ceiling tile with speaker (suspended
ceiling) or remove speaker from drywall and
disconnect the cable connected to the transformer
input wires.
Step 2.
Cut the transformer output wires leaving excess
wire for the speaker wire connections. Strip wire
ends back 3/8 inch.
Step 3.
Magnetically attach the
PSA-IP
to the back of the
speaker magnet. Alternatively, the
PSA-IP
can be
attached to the 70V transformer mounting holes in
the speaker frame with provided screws.
Step 4.
Cut off the terminals from the
PSA-IP
’s red and
black speaker output wires and strip wire ends back
3/8 inch. Attach red and black wires from
PSA-IP
“Speaker” output to the speaker wires using
provided lever connectors.
Note:
Third lever
position is used to connect additional speakers
.
Step 5.
Attach a Cat5 or higher cable to the PSA-IP LAN
w/POE port. See Typical Installation section for
details.
