11
Standard Multicast Paging Tab
The security code allows the user/installer to program the
PSA-IP
with a PC and the required ‘Viking IP Programming”
software. If the security code is left as default, the PC software won’t require entering a security code when connecting
to the
PSA-IP
. It is recommended that the factory set security code be changed. The security code can be set back to
default by holding the Reset button while the
PSA-IP
powers up. See section D on page 9 for details. It can also be
defaulted by connecting to the unit with the IP Programming Software and clicking on the “Clear Speaker Settings”
button on the “Alarm / Firmware” tab.
Factory Setting:
845464
NOTE:
The security code must be 6 digits and cannot include a
Q
or #.
7. Security Code
Select Standard or Polycom as the source of multicast paging. If Polycom is selected as the source, the screen will
change to show its options (see next page). For Details see #11 on Page 13.
Factory Setting:
Standard (shown above)
9. Pre Page Tone
When enabled, a short beep will be heard prior to SIP or Multicast paging audio. The volume of the Pre Page Alert Tone
will match the volume setting of the SIP or Multicast page.
Factory Setting:
Enabled
10. Multicast Page Type
The Access Code is primarily used along with the “Auto Answer Secure” Inbound Call Mode to force inbound SIP page
callers to dial the Access Code before they can make a SIP page. The Access Code also comes into play when using
the relay of the
PSA-IP
to open a door or gate. When you call the
PSA-IP
and the unit automatically answers the call
(see Programming section 38), you must dial the Access Code before you are allowed to operate the door strike relays,
as extra security on inbound calls. Once a tenant has entered the correct Access Code, 2 beeps are heard and the user
can now enter any “Operation Commands” (see Operation section D). The Access Code can be disabled if this basic
security is not required.
Factory Setting:
123456
Note:
The Access Code can be 1 - 6 digits in length and cannot include a
Q
or # or match the numbers used for the
Security Code.
8. Access Code
