• Before beginning, please read these instructions completely and
carefully.
• DO NOT remove permanently affixed labels, warnings, or plates
from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• Please ensure that this product is properly grounded.
• The installer should leave these instructions with the consumer who
should retain for local inspector’s use and for future reference.
It is your responsibility to be sure your ice machine is:
• located so the front is not blocked to restrict incoming or discharge
air flow.
• properly leveled.
• located in a well ventilated area.
• connected to the proper kind of outlet, with the correct electric
supply and grounding. A 115V, 60 Hz, 15 amp fused electrical
supply is required.
Note: Time delay fuse or circuit breaker is
recommended.
• not used by anyone unable to operate it properly.
• used only for its intended purpose.
• properly maintained.
•SAVE THESE INSTRUCTIONS•
WARNING
To reduce the risk of fire, electric shock, or injury when using your unit, follow these
basic precautions:
• Read all instructions before using the unit.
• Never allow children to operate, play with, or crawl inside the unit.
• Never clean unit parts with flammable fluids. The fumes can create a fire
hazard or explosion.
• Always turn the power on/off switch (located behind the air grille on top right
side) to the OFF position before attempting to change light bulbs, clean, or
service the unit.
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND
LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. THE FUMES
CAN CREATE A FIRE HAZARD OR EXPLOSION.
1. Turn on the water supply.
2. Switch on the electrical power.
3. Push and release the On/Off switch to start the machine. The Ice
Making light next to the On/Off switch will glow Blue.
Warm air will flow out of the left front grill.
It will take about 10 minutes for the ice machine to begin dropping
nugget ice into the storage bin. It is normal for that ice to melt and ice
will continue to melt, but at a slower rate. It will take about 6 - 7 hours
to fill up the ice storage bin. The bin holds about 20 lb of ice when full.
Ice level control
The ice level control is an ultrasonic sensor, located above the ice
storage area. It is automatic and there is no adjustment to make. When
ice melts or is used, and the ice level drops below a preset distance
the control turns the ice making system back on. It makes ice until the
preset level is reached. Placing your hand in the unit to remove ice
does not affect the ice level.
Using Your Ice Machine
No special instructions are needed for use. Just take as much ice as
you need, the machine will replace it. A scoop is provided, and it can
be stored in the machine using the loop of tubing on the right side as
a holder.
The machine can be shut off anytime by just pushing and releasing the
ON/OFF button. During the ice making, nugget ice will drop into the
bin at an irregular rate. Sometimes there will be little ice fallilng while
at other times, a group of nuggets will fall. Some water drops may also
come out with the ice. Both conditions are normal.
It is designed to operate in wide range of air temperatures:
-Minimum air temperature: 50 degrees F.
-Maximum air temperature: 100 degrees F.
ON/OFF
ICE
MAKING
CHECK
WATER
TIME TO
CLEAN
CLEAN
RESET
4
5
Important - Please read and follow
Initial Start Up
