Viking ME 443, Инструкция по эксплуатации, Страница: 47 / 284

45
DE
FR
NL
IT
ES
PT
NO
SV
DA
EL
RU
EN
0478 121 9920 C - EN
Cleaning position ME 443:
●
Detach the grass catcher box. (
Ö
8.3)
●
Hold the upper handlebar (1) and open
the quick-clamping devices – fold
downwards.
●
Set down the upper handlebar (1)
rearwards.
●
Open the discharge flap (2) and hold it
open.
●
Lift up the machine at the front and
place in the cleaning position as shown.
Check that the machine is stable.
Cleaning position ME 443 C:
●
Detach the grass catcher box. (
Ö
8.3)
●
Open the discharge flap (2) and hold it
open.
●
Press the detent lever (3) downwards
with the thumb and hold.
●
Hold the machine at the front
handle and tilt it slowly rearwards.
●
Release the discharge flap (2) and
check that the machine is standing
securely.
1
2.3 Electric motor and wheels
The electric motor is maintenance-free.
The wheel bearings are maintenance-free.
1
2.4 Upper handlebar ME 443
Maintenance interval:
Before each use
The upper handlebar is coated with a
insulating layer. Should this layer become
damaged, the upper handlebar must be
replaced.
1
2.5 Mowing blade maintenance
Maintenance interval:
Before each use
●
Tilt the mower upwards into the
cleaning position. (
Ö
12.2)
●
Clean the mowing blade (1) and check
it for damage (notches or cracks) and
wear; replace if necessary.
●
Use a slide calliper (not included in
standard equipment) to measure blade
thickness at 5 points at least. In
particular, the minimum thickness must
also be ensured in the area of the blade
wings.
●
Place a ruler (2) against the front blade
edge and measure permissible
grinding.
Wear limits:
Distance A:
The cutting edges may not be ground back
by more than
1
5 mm
.
Distance B:
The minimum width of the mowing blade
must not be less than
39 mm .
Distance C:
The blade thickness must be at least
2 mm
at any point.
The check should be performed using a
slide calliper.
If the supplied standard blade is not
installed in the lawn mower, but e.g. the
multi-blade, which is available as a special
accessory, different wear limits apply.
Danger of pinching!
After actuation of the detent lever,
the upper handlebar can fall to the
lowest position under its own
weight.
Never place your finger between
the handlebar and the handlebar
console (under the detent lever).
1
6
Risk of injury!
A worn or damaged mowing blade
may break off and cause serious
injuries. The instructions for blade
maintenance must therefore always
be observed.
Blades are subjected to differing
degrees of wear depending on the
location and duration of use. If you
use the machine on sandy ground
or use it frequently under dry
conditions, the blade will be
subjected to greater loads and will
wear more quickly than the
average.