Power:
5 to 14V DC @ 60mA maximum
Maximum Cable Length:
500 ft 24 Awg stranded shielded
(Belden 9537)
Frequency:
125KHz
Format:
26 bit Wiegand
Read Range:
1.25” to 2.0”
Technologies Supported:
Viking
PRX-C
,
PRX-C-ISO
,
PRX-FOB
,
LRT-4
, certain legacy HID® proximity protocols*
and certain AWID 125Khz proximity protocols**
Transducer:
Beeps during card read
LED:
Red, turns off during card read
Humidity:
Up to 100% (fully potted EWP)
Operating Temperature:
-34° C to 65° C (-30° F to 150° F)
* HID and the HID logo are registered trademarks of HID
Global Corporation, an ASSA ABLOY company. All other
trademarks are the property of their respective owners.
** AWID is a trademark of Applied Wireless Identification Group.
Power:
6-22V DC 150mA (12V DC UL Listed adapter included)
Image Sensor:
1/4” color CMOS
Video Output:
1 VP-P composite, NTSC, 75 ohms
Resolution:
420 lines (640 x 480 @ 30fps / 307,200 pixels)
Sensitivity:
0.025 LUX (50 IRE) F 1.2 3200K
Lens:
2.1mm, conical pinhole
FOV
(
Field of View)
: 80° Horizontal, 60° Vertical, 100° Diagonal
Tilt/Swivel Adjustment:
Ve/- 20°, hori/- 30° (see
Diagram A
)
IR Compatibility:
This camera is equipped with an OLP
(Optical Low Pass) filter to maintain correct video color
in outside applications. The standard camera is
NOT
compatible with IR illuminators. If IR illumination is
required, you will need to replace the exisiting camera
with a Viking model
VCAM-1IR
. For more information,
see
DOD# 190
.
Maximum Wire Run Length:
1000 ft with *RG59/RG6 for video and
CAT5 for power (1 pair) and entry phone audio (1 pair). 150 ft with
CAT5E for video, power and entry phone audio (longer video runs
are possible by using video balun transceivers, see
Installation
section
D
, page
4
* Note:
RG59 or RG6 with solid center conductor and
95% bare copper braid shield.
Proximity Card Reader Specifications
Camera Specifications and Adjustments
Fea tures Overview
Keypad:
Push to initiate call, push
again to disconnect. Zinc Die cast
with Satin Chrome Finish, internally
sealed per IP67.
Speaker Screen:
Speaker screen
with 0.018" wide slots to prevent
punctures from paperclips, etc.
Faceplate Material:
14 gauge 316
stainless steel with #4 brushed
finish.
Speaker:
Mylar speaker with
rubber gasket to maintain
water-tight seal and eliminate
water deterioration.
Blue Call LED:
Lights steady to
help locate the button in low light,
flashes during dialing, then lights
steady when answered.
Microphone:
Omni-directional
microphone with protective
water-resistant cloth.
Front View of the
K-1275 Entry Phone
Condensation Drain Hole
Mounting Screws:
(8) 6-32 X 3/4”
Marine grade 316 stainless steel,
flat head, T-10 Torx security
screws and drive bit (included).
Laser Etched Graphics:
For long
lasting easy to read graphics.
VIKING
©
1
2
3
4
5
6
7
8
9
0
#
*
#
*
0
9
8
7
6
5
4
3
2
1
1
2
3
4
5
6
7
8
9
0
#
*
Color Video Camera:
Wide
operating temperature range of -40°F
to 140°F, NTSC composite video
output with 420 lines of resolution,
80° wide viewing angle lens, tilt and
swivel adjustments for aiming
towards visitors.
Protective Camera Window:
Impact resistant polycarbonate lens
with scratch resistant coating and
water-tight gasket.
Proximity Card Reader:
26-bit
Wiegand, 125KHz, red LED turns off
and transducer will beep during card
read. Fully potted EWP. Read range
1.25" to 2.0". Impact resistant
polycarbonate lens with water-tight
gasket.
Vertical (Tilt)
Adjustment
+/- 20 degrees
maximum
Horizontal (Rotation)
Adjustment
+/- 30 degrees maximum
2
80° Lens FOV
Rotate
Left 30°
Rotate
Right 30°
Camera Lens
Diagram A
Camera Horizontal Field of View:
Camera Adjustments:
The camera can be tilted and rotated to your desired
position. A portable service (test) monitor can be used
to determine the correct viewing angle during
installation.
Important:
To prevent the edge of the faceplate from
being viewed in the video image, do not rotate the
camera beyond 30 degrees or tilt beyond 20 degrees.
