3
B . E-32 / E-32-EWP
3.65"
Wide
Min.
2.84"
Tall Min.
*2.25"
Deep
Min.
CON
NECT
ED
Call
VIKIN
G
©
"Old Work" Double Gang
Rough-In Box
(Allied Molded 9312 box
shown, not included)
(4) Optional
Dry Wall
Screws
(not included)
5.0”
Typical
Peel paper liner and adhere gasket
to back of panel, centering over the
mounting holes.
Laser Etched Graphics
(4) T-10 Torx stainless steel, flat head,
security screws and drive bit
(included)
Push to Call Button
The
E-32
is designed to be flush mounted to a standard double gang electrical box with minimum dimensions of: 3.65”W
x 2.84”H x 2.25”D.
Note:
When mounting outside to rough or uneven surfaces (brick, stucco, etc.) apply a bead of clear silicone caulking
around the top edge and sides of faceplate. For surface mount applications, use model
E-30
or
E-30-EWP
with a
VE-5x5
surface mount box.
Dimensions:
Overall: 5” x 5” x 2.25” (127mm x 127mm x 57mm)
Faceplate:
14 gauge 316 stainless steel with #4 brushed finish
Shipping Weight:
2.12 lbs (1.0 kg)
* Caution:
Excessive wire length and/or using a rough-in box with inadequate depth can apply force to the circuit board
causing physical damage.
Important:
When warm air comes in contact with cold surfaces, such as outside walls and conduits, it causes
condensation. To prevent condensation from accumulating inside the
E-1600-32A
always bring conduit into the bottom
of the unit. If this is not possible, drill a 1/4” diameter hole in the bottom of the double gang box.
