47
6
Open freezer door. Remove door trim screws and door
trim with a phillips screwdriver.
Install “Z” brackets onto back side of custom panel.
Note:
If 1/4” back panel is used, the brackets will be flush to the
edge (back panel is 1/4” smaller than 3/4” panel dimension).
1
2
1/4”
off edges of
3/4 “ panel
Align panel in door trim and push down evenly.
Ensure side and bottom “Z” bracket engagement with door trim.
Reinstall top door trim and door trim screws with a
phillips screwdriver.
3
4
46
Remove handle side cabinet screws and trim
with a phillips screwdriver.
Remove handle side door trim screws and panel
with a phillips screwdriver.
Install “Z” brackets onto back side of custom panels.
Note:
If 1/4” back panel is used, the brackets will be
flush to the edge (back panel is 1/4” smaller than
3/4” panel dimension).
Proper “Z “brackets engagement.
Note:
A 1/4” back panel needs to be used to ensure proper
insulation. If back panel is not used, the potential for
condensation is present.
For the last 3” of installation, push evenly on the custom wood panel
near the side door trim in addition to pushing from the handle side.
This ensures side “Z” bracket engagement with hinge side door trim.
1
2
3
1/4”
off edges of
3/4 “ panel
1/4” (0.5 cm) back panel
Door
Door trim
“Z” bracket
3/4 “ (1.9 cm) custom panel
TOP VIEW
3”
4
5
Custom Door Panel Installation (Refrigerator or Freezer)
Custom Freezer Door Panel Installation (Bottom Mount Only)
Insert handle-side door trim making sure to engage
handle-side “Z” bracket in door trim. Install door trim screws.
7
Reinstall cabinet trim and screws.
Align upper and lower “Z “brackets in door trim and
push custom wood panel evenly toward the hinge until
approximately 3” from the hinge side door trim.
