45
Remove two additional screws under top
section of bezel.
Remove mounting support.
Grasping the bezel on both sides, pull away from
the door cavity.
Note:
Bezel needs to be pulled from the bottom
first and then pull slightly downward to clear
the water dispensing tube.
Store bezel and spill tray in safe and secure place until
installation.
5
6
7
3
8
Custom Panel General Information
Custom finishing options
• All installations must allow for the
refrigerator ad freezer door to open a
minimum of 90˚.
• For side wall or corner installation, allow
for a standard 3” (7.6 cm) cabinet filler to
assure door(s) open 90˚.
Note
:
If a custom handle is used a wider
filler may be necessary.
• Panel thickness must not exceed 1”
(2.5 cm) on hinge side. Thicker panels will
interfere with door swing and clearance.
• A 1/4” wood filler or insulation filler must
be used between the door and 3/4” wood
panel to prevent condensation from
forming.
44
Ice and Water Dispenser Bezel Removal (if required)
Remove packaging material surrounding bezel.
Grasping the sliding lever, pull away from bezel.
Remove spill tray form lower part of bezel
exposing two screws.
Remove screws.
1
2
4
3
For re-installation steps see pages 48-49.
