Page18
15” & 24” Series
Technical Services Manual
SMR-0014
(Defrosting continued...)
TURN OFF, OR UNPLUG THE UNIT BEING SERVICED
To defrost the evaporator coil, remove the shelves or drawers out of the cabinet. Remove all four of
vertical shelf supports. Pull the top edge of the rear panel towards you until it get to a 45 degree angle.
Now lift the panel up and out of the cabinet. This will expose the evaporator coil.
Using a hair dryer or heat gun, carefully remove all ice, remembering to use rags or sponges to catch
melted water. When complete, reinstall all components.
Light Bulb Replacement
The light is located just behind the temperature
control housing. To replace a defective or burnt
out light bulb, simply unscrew the bulb counter-
clockwise and replace with an identical LED bulb,
Viking number
67026
.
Door Switch Replacement
CAUTION:
DISCONNECT POWER TO THE
CABINET BEFORE SERVICING.
With the front grille removed, depress the two met-
al ears on the back side of the support bracket, at
the same time pulling the switch forward. Transfer
the wires one by one to the new switch. Push the
switch back into place, making sure that the metal
tabs are pushed through the bracket, holding the
switch securely.
