7
FINAL PREPARATION
1. Some stainless steel parts may have a plastic protective wrap which must be peeled off. All stainless steel body
parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material. If build-up
occurs, do not use steel wool, abrasive cloths, cleaners, or powders!! If it is necessary to scrape stainless steel to
remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper.
Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel! Scratches are almost
impossible to remove.
2. The interior of the oven should be washed thoroughly with hot, soapy water to remove film residues and any
installation dust or debris before being used for food preparation, then rinsed and wiped dry. Solutions stronger
than soap and water are rarely needed.
REPLACEMENT PARTS
Only authorized replacement parts may be used in performing service on the range. Do not repair or replace any
part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a
qualified technician.
DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE. SUCH USE MAY RESULT IN A FIRE,
ELECTRICAL SHOCK, OR OTHER PERSONAL INJURY.
6
WOOD/COMPOSITE OVERLAY INSTALLATION
(Including Custom Ventilator Installation)
The bottom of a standard hood should be 30” (76.2 cm) min to 36” (91.4 cm) max above the ceramic glass surface.
This would typically result in the bottom of the hood being 66” (167.6 cm) to 72” (182.9 cm) above the floor. Refer to
the rangehood installation instructions for further information. These dimensions provide for safe and efficient
operation of the hood.
30” (76.2 cm) min
36” (91.4 cm) max
66” - 72”
(167.6 cm -
182.9 cm)
30” (76.2 cm) min
36” (91.4 cm) max
66” - 72”
(167.6 cm -
182.9 cm)
36”
(91.4 cm)
ISLAND INSTALLATION
WALL INSTALLATION
36”
(91.4 cm)
Metal Hood
Metal Hood
Wood/Composite Overlay
Wood/Composite Overlay
Countertop
ELECTRICAL CONNECTION
With the rangetop positioned in front of the cabinet opening, connect the wire
leads extending from the conduit to the junction box, making sure the neutral
(white) wire is connected to the appropriate terminal. Check your local codes to
see which of the options below should be used in grounding the unit. Do not
use GFI circuit.
OPTION 1
Connnect the neutral (white) wire and the grounding (bare) wire
with the incoming neutral (white) power supply lines.
OPTION 2
If the junction box is grounded, untwist the grounding (bare) wire
and attach to the junction box. Attach the neutral (white) wire to
neutral (white) power supply line.
OPTION 3
Untwist the grounding (bare) wire and attach it to a suitable
ground. Attach neutral (white) wire to the incoming neutral (white)
power supply line.
Identification Label Location -
(bottom of unit in left rear corner)
Countertop
