3
Description
VERT301-4B
DERT301-4B
DERT361-5B
Overall Width
29 7/8” (75.9 cm)
29 7/8” (75.9 cm)
35 7/8” (91.1 cm)
Overall Height
BASE HEIGHT
BASE HEIGHT
To top of
To top of
glass frame - 7 7/8” (20.0 cm)
side trim - 6 1/8” (15.6 cm)
ADDITIONS TO BASE HEIGHT
To top of island trim add 1 1/4” (3.2 cm)
add 0” (0 cm)
To top of backguard add 6” (15.2 cm)
add 6” (15.2 cm)
To top of high-shelf add 23 1/2” (59.7 cm)
add 23 1/2” (59.7 cm)
Overall Depth from To end of:
Rear
side panel -
24” (61.0 cm)
24 7/16” (62.1 cm)
control panel - 25 15/16” (65.9 cm)
26 1/8” (66.35 cm)
knobs -
27 7/16” (69.7 cm)
27 5/8” (70.2 cm)
Cutout Width
30” (76.2 cm)
30” (76.2 cm)
36” (91.4 cm)
Cutout Height
7 1/2” (19.1 cm)
5 3/4” (14.6 cm)
5 3/4” (14.6 cm)
Cutout Depth
24” (61.0 cm)
24 7/16” (62.1 cm)
24 7/16” (62.1 cm)
Electrical Connection 40 amp
40 amp
50 amp
Requirements
3-Wire, 240/208 VAC, 60 Hz. Unit is equipped with No. 10 ground wire in conduit. Should be
fused separately.
Maximum Amps
240V- 34.6 amps
240V- 35.0 amps
240V- 45.0 amps
208V- 29.8 amps
208V- 30.3 amps
208V- 40.0 amps
Surface Elements
240V
208V
240V
208V
240V
208V
Left Front
1500 watts
1125 watts
1800 watts
1350 watts
1800 watts 1350 watts
Bridge
N/A
N/A
800 watts
600 watts
800 watts 600 watts
Left Rear
2400 watts
1800 watts
1800 watts
1350 watts
1800 watts 1350 watts
Center
N/A
N/A
N/A
N/A
2700 watts 2025 watts
Right Front
1800 watts
1350 watts
1500 watts
1125 watts
1500 watts 1125 watts
Bridge
800 watts
600 watts
N/A
N/A
N/A
N/A
Right Rear
1800 watts
1350 watts
2500 watts
1875 watts
2200 watts 1650 watts
Approximate
110 lbs. (49.5 kg)
52 lbs. (23.4 kg)
63 lbs. (28.4 kg)
Shipping Weight
SPECIFICATIONS-ELECTRIC RANGETOP
Minimum clearances from adjacent combustible construction
•Cooking surfaces and below (36”[91.4 cm] and below)
•Sides- 0”
•Rear- 0” with backguard or highshelf; 0” with island trim and non-combustible wall;
6” (15.2 cm) with island trim and combustible rear wall
•Top grate support - 36” (91.4 cm)
•Above cooking surface (above 36”[91.4 cm])
•Sides- 6” (15.2 cm)
•Within 6” (15.2 cm) side clearance, wall cabinets no deeper than 13” (33.0 cm) must be minimum 18” (45.7 cm)
above cooking surface.
•Wall cabinets directly above product must be minimum 36” (91.4 cm) above cooking surface
It is not recommended to install two or more units side by side.
IMPORTANT: PLEASE READ AND FOLLOW
• Before beginning, please read these instructions completely and carefully.
• Do not remove permanently affixed labels, warnings, or plates from product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• Please ensure that this product is properly grounded.
• The installer should leave these instructions with the consumer who should retain for local inspector’s use
and for future reference.
Installation must conform with local codes or in the absence of codes, with the National Electrical Code, ANSI/NFPA
70-latest edition. In CANADA: Electrical installation must be in accordance with the current CSA C22.2 Canadian
Electrical Codes Part 1 and/or local codes.
GENERAL INFORMATION
1.
WARNING
:
The use of cabinets for storage above the appliance may result in potential fire or burn hazard.
Combustible items may ignite, metallic items may become hot and cause burns. If a cabinet storage is to be
provided the risk can be reduced by installing a rangehood that projects horizontally a minimum of 5” (12.7 cm)
beyond the bottom of the cabinets.
2.
WARNING
:
This appliance shall not be used for space heating. This information is based on safety
considerations.
3. All openings in the wall behind the appliance in the floor under the appliance shall be sealed.
4. Keep appliance area clear and free from combustible materials, gasoline, and other flammable vapors.
5. Disconnect the electric supply to the appliance before servicing.
6. When removing oven for service and/or cleaning, disconnect AC power supply.
7. Electrical requirements:
Listed in specifications chart. Electrical installation should comply with national and local codes.
WARNING!!!
ELECTRICAL GROUNDING INSTRUCTIONS
This rangetop must be electrically grounded in accordance with local codes or, in the
absence of codes, with the National Electrical Code, ANSI/NFPA 70-latest edition.
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.
BACK TRIM ACCESSORIES
Assembly and installation instructions are included with all back trim accessories.
2
