7
CUT COUNTERTOP OPENING
1. Lay out and cut the cooktop cut-out far enough FORWARD
so downdraft will fit behind it.
2. Set cooktop in place and slide it as far forward as possible
without exposing an gaps. Center and square it with edges
of countertop.
3. Place the plastic template against the back flange of the cook-
top or back edge of slide-in range countertop opening. Center
the template. Trace around template to mark the downdraft
opening.
4. Remove cooktop from countertop.
5. Cut downdraft opening. Be careful not to chip edges of coun-
tertop.
INSTALL HOUSING INTO
CABINET
1. Remove cooktop.
2. Set housing into cabinet / countertop opening as far back as
possible and make sure it is level.
3. Extend
SUPPORT LEGS
and attach to bottom of cabinet with
(2) SCREWS
through each leg. Tighten
HEX SCREWS
.
If cabinet bottom is removed:
Use blocks as spacers between floor and support
legs.
SUPPORT
LEG
(2) #10 X
.500 WOOD
SCREWS
HEX
SCREW
4. Extend
UPPER SUPPORT BRACKETS
and attached to sides
of cabinet with
(2) SCREWS
through each bracket.
UPPER
SUPPORT
BRACKET
5. Loosen
(4) SCREWS
attaching
BLOWER SUPPORT LEGS
to
FLEX BLOWER
. Extend legs and secure them to bottom of
cabinet with a
SCREW
through each bracket.
FLEX
BLOWER
(4) 1/4-20 X
.500
SCREWS
SCREWS
Installations using FLEX BLOWER only:
Template against back
edge of cooktop.
COOKTOP
(2) #10 X .500
WOOD SCREWS
